Alle Beiträge (AndreasSimfors)
Holder B16/Lombardini LA 490 electronic ignition |
||
|---|---|---|
|
Schaut nur mal vorbei
 
Registriert seit:
22.06.2022 Gruppe:
Registrierte User Beiträge:
4
 |
Hi
I'm in Sweden, preparing for winter dutys. My Holder B16 does not run very well and I need to change sprakplugs every now and then. Fuel lines, petrol shutoff valve and carburettor is new. Also the capacitator is new. I'm now looking at the electronic ignition conversion kits I find online for the Lomabardini LA 490 engine. But I'm not sure about the function? Neither theoretically nor practically! - How are they supposed to work without the breakers? - Anyone tried one of those kits? Results? - Are instructions included? Is it easy to install and adjust? - Should I just get a regular replacement ignition coil instead? Best regards/Andreas
Geschrieben am: 18.11.2023
|
|
 Übertragung
|
|
|
Re: B16, front lift attachment [english] |
||
|---|---|---|
|
Schaut nur mal vorbei
Registriert seit:
22.06.2022 Gruppe:
Registrierte User Beiträge:
4
|
Yes, I have the front PTO, but these extra arms could not lift anything, since they're acting backwards. The one-way hydraulics can only push them down, not lift them.
...and I've got rid of them now!
Geschrieben am: 18.11.2023
|
|
|
Übertragung
|
|
|
Re: B16, front lift attachment [english] |
||
|---|---|---|
|
Schaut nur mal vorbei
Registriert seit:
22.06.2022 Gruppe:
Registrierte User Beiträge:
4
|
Hi
Yes, I'm convinced my front hydraulics are modified. Welds look a bit homemade and they are painted by hand, not sprayed. Question is why? I cannot see the use of this addition since they're not capable of lifting. Anyway, I have decided to cut them off. Regards/Andreas
Geschrieben am: 07.07.2022
|
|
|
Übertragung
|
|
|
B16, front lift attachment [english] |
||
|---|---|---|
|
Schaut nur mal vorbei
Registriert seit:
22.06.2022 Gruppe:
Registrierte User Beiträge:
4
|
Hi, I hope it’s OK to ask a question in english!
Just got my hands on an old B16. Going over it I found these ”horns” welded to the front lift. Doesn’t seem factory, and the action is kind of reversed since the hydraulics push it downwards instead of lifting it. Any ideas about the use of these? What kind of attachement is it for? Finally; should I just cut them of?! I think they are ugly and futhermore, they are in the way of the front lift bolts, making it hard to attach the snowplow to the front lift! Regards/Andreas, Schweden Datei anhängen:  PNG-bild.png (785.87 KB)
Geschrieben am: 02.07.2022
|
|
|
Übertragung
|
|
|
